Magnobond 86 and 87, Parts A & B

1. Magnobond 86 meets the requirements of STM-22-602C, Type IV, Grade A, Class 1.
2. Magnobond 87 meets the above specification when a Grade B (thixotropic) material is desired.
3. These products have a long enough pot life for use during an entire shift.
4. Outstanding physical strengths are maintained at temperatures in excess of 350°F.

     Part A             100 parts by weight
     Part B               8 parts by weight

The best properties of Magnobond 86 and 87 are obtained using
the following cure schedule:

     24 hours at 75 - 80°F followed by
      2 hours at 200°F and 3 hours at 350°F

     Density, lbs./inch3                0.029 lb/cu in
     Compressive Strength, psi
        75°F at 0.032 inch deformation  13,400
        350°F at 0.45 inch deformation   5,800
     Adhesive Strength at 350°F, psi       875
     Water absorption, %, 24 hours        0.12
     Machineability                     Satisfactory
     Voids                              Satisfactory
     Impact Resistance                  Satisfactory
     Flow:
        Magnobond 86, cps               85,000
        Magnobond 87, inches              0.01

CAUTION

A severe exotherm can be encountered in the use of this product when the temperature is run directly to 190°F.

            DANGER                            FIRST-AID
--------------------------------     -------------------------
May cause severe irritation.         Eyes - Immediately flush
Do not get in eyes, on skin          eyes with plenty of water
or clothing.                         for at least 15 minutes.
Do not inhale vapors.                Get medical attention.
Wear rubber gloves & aprons.         Skin - Wash immediately
Use with adequate ventilation.       with soap and water.
Wash thoroughly after handling.      Clothing - Remove clothing
For industrial use only.             and wash before reuse.
Keep container closed.
Do not reuse this container.

Spec Sheet Dated: 11/16/93

Sales Division
Magnolia Plastics, Inc.
5547 Peachtree Industrial Boulevard
Chamblee, GA 30341-2296  USA
770-451-2777, Voice
770-451-5376, FAX
800-831-8031, Voice
Email:   sales@magnapoxy.com

How To Order:

Copyright © 1996, Magnolia Plastics, Inc. All Rights Reserved, including the right of reproduction in whole or in part in any form. The stylized Magnolia Plastics logo is a regsitered trademark of Magnolia Plastics, Inc.

Contact Magnolia at sales@magnapoxy.com

Web Page Construction and Maintenance By: IFDS Enterprises, Inc.